https://doi.org/10.1051/epjconf/20122502024
Experimental verification of numerical optimization of a plunger for glass pressing
1
Technical University of Liberec, Department of
Mathematics and Didactics of Mathematics, Studentská 2, Liberec 1, 461 17
petr.salac@tul.cz
2
Technical University of Liberec, Department of
Power Engineering Equipment, Studentská 2, Liberec 1, 461 17
vaclav.dvorak@tul.cz
The main aim of these experiments is to verify the results of numerical optimization described in [1], [2], [3] and [4]. The results of measuring the classical plunger with its drilled internal cavity and the optimized plunger with its sparked-out inner cavity and applied flow control body are presented in this article. The temperature distributions across both plunger surfaces are estimated by values measured at four points placed 5 millimetres under the plunger surfaces.
© Owned by the authors, published by EDP Sciences, 2012
