Failure stress criterion for adhesively bonded joint at different strain rates by using dynamic Arcan test device
1 University of Valenciennes and Hainaut Cambrésis, LAMIH, UMR CNRS 8201, 59313 Valenciennes, France
2 ENSTA Bretagne, LBMS EA 4325, 29806 Brest Cedex 9, France
a Corresponding author: firstname.lastname@example.org
Published online: 7 September 2015
The purpose of this work is to determine the failure criterion evolution of assembly bonded with a strain rate dependent adhesive. A new modified ARCAN device is then designed to obtain the average stress at failure under different loading angles and for strain up to 350 s−1. Tests are performed on a hydraulic jack machine and a Digital Image Correlation measurement is used to control the opening and the sliding displacements of the two substrates.
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.