https://doi.org/10.1051/epjconf/201921302002
Experimental Study of a Boundary Layer on a Heated Flat Plate
1
Institute of Thermomechanics of CAS, Dolejškova 5, 182 00 Prague, Czech Republic
2
Institute of Theoretical and Applied Mechanics of CAS, Prosecká 76, 190 00 Prague, Czech Republic
* Corresponding author: antos@it.cas.cz
Published online: 28 June 2019
Boundary layer on a uniformly heated flat plate was studied experimentally. Both, the velocity boundary layer and the temperature boundary layer, was investigated by means of hot-wire anemometry. A probe with parallel wires was used for velocity-temperature measurement. Experiment was performed in the closed-circuit wind tunnel with several levels of heat flux at the wall. The wall temperature was set up in the interval from 20 ºC to 200 ºC.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
