https://doi.org/10.1051/epjconf/201921302004
Simulation research of the temperature distribution during face milling
1
Department of Mechanics, Kielce University of Technology ; Aleja Tysiąclecia Państwa Polskiego 7 ; 25-314 Kielce, Poland
2
Department of Mechanical Technology and Metrology, Kielce University of Technology ; Aleja Tysiąclecia Państwa Polskiego 7 ; 25-314 Kielce ; Poland
* Corresponding author: mdrab@tu.kielce.pl
Published online: 28 June 2019
The paper presents the results of numerical calculations showing the temperature distribution of the workpiece (copper) during the face milling process. The ANSYS program was used for simulation studies. The calculations were carried out for two different cutting speeds, examining their influence on the temperature of the workpiece. The calculations constitute the basis for further research in order to determine the influence of variable temperature fields on the thermal expansion of the workpiece and to estimate the dimensional accuracy of the parts to be made during milling.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
