https://doi.org/10.1051/epjconf/201921302024
The effect of material mixing on heat transfer in the process of contact drying
Czech Technical University in Prague, Faculty of Mechanical Engineering, Department of Energy Engineering, Technická 4, 16607 Prague, Czech Republic
* Corresponding author: jan.havlik@fs.cvut.cz
Published online: 28 June 2019
This paper deals with the process of heat transfer in contact drying. Heat transfer during contact drying for a stagnant bed without mixing and drying with a mechanically agitated bed were theoretically and experimentally investigated for a contact paddle dryer. The effect of material mixing on the process of heat transfer was evaluated. For a theoretical description of heat transfer in a contact dryer, the penetration model was used. Experiments with green wood chips were realized on an experimental paddle dryer. In both cases, the stagnant bed and the mechanically agitated bed, the theoretical values were slightly higher compared to the experimental results. Mixing intensifies the process, it showed an increase to roughly twice in heat transfer for the tested experimental dryer.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
