https://doi.org/10.1051/epjconf/201922405009
Effects of Milling Parameters on Distribution of Residual Stress During the Milling of Curved Thin-Walled Parts
a
College of Mechanical Engineering, University of Shanghai for Science & Technology, CN-200093, Shanghai, China
b
Shanghai Space Propulsion Technology Research Institute, CN-201109, Shanghai, China
c
College of Mechanical Engineering, Donghua University, CN-201620, Shanghai, China
d
Moscow State Technological University “STANKIN”, Department of Cutting Tools and Forming Technologies, RU-127055, Moscow, Russia
* e-mail: jiangxh@usst.edu.cn
Published online: 9 December 2019
With the increasing application of curved thin-walled parts, the evaluation and control of curved surface residual stress in milling are becoming increasingly demanding. However, effects of milling parameters on distribution of residual stress remains a major challenge in the present aerospace research areas. In this paper, , impacts of milling parameters on curved surface residual stress have been investigated in a series of residual stress experiments and simulations. It is found that the residual stress can be lowered by increasing milling speed and tool radius within a reasonable range. The superposition of curved surface residual stress under two machining conditions have been analyzed using the milling simulation model. It has been found that the curved surface residual stress induced by the subsequent cutting will be superimposed on the curved surface residual stress induced by the previous cutting and that the superposition rates of residual stress induced by up milling are larger than down milling.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.