https://doi.org/10.1051/epjconf/202124905006
Influence of the coefficient of restitution on the classification of granite sand using an elutriator
1
Departamento de Ciencias Básicas, Facultad de Ingeniería, Universidad Nacional del Centro de la Provincia de Buenos Aires (UNCPBA). Av. Del Valle 5737 – 7400 Olavarría – Argentina
2
Department of Metallurgical and Materials Engineering, Universidade Federal do Rio de Janeiro – COPPE/UFRJ, Cx. Postal 68505, CEP 21941-972 Rio de Janeiro, RJ, Brazil
3
Planta Piloto de Ingeniería Química (PLAPIQUI), Universidad Nacional del Sur – CONICET. Camino La Carrindanga km. 7 - 8000 Bahía Blanca – Argentina
4
Laboratorio de Micropartículas, Centro de Investigaciones en Física e Ingeniería (CIFICEN), dependiente de UNCPBA-CICPBA-CONICET. Av. Del Valle 5737 – 7400 Olavarría – Argentina
5
Departamento de Ingeniería Química, Facultad de Ingeniería, UNCPBA. Av. Del Valle 5737 – 7400 Olavarría – Argentina
6
Departamento de Ingeniería Civil, Facultad de Ingeniería, UNCPBA. Av. Del Valle 5737 – 7400 Olavarría – Argentina
* Corresponding author: eborsa@fio.unicen.edu.ar
Published online: 7 June 2021
The objective of this work was to measure the coefficient of restitution of fine granite sand dust (passing sieve ASTM N°30) and to study its influence on the prediction of classification parameters in an elutriator device. Three types of restitution coefficients were evaluated in the computational fluid dynamic model: experimental, elastic, and half the experimental value. The influence of process variables, such as the inclination angle of the equipment and the air inlet velocity, on the efficiency of the obtained fine and coarse fractions was also studied. The results indicate that the coefficient of restitution significantly influences the efficiency parameters calculated for the inclined tests, given the greater contact that exists between the particles and the equipment wall. The experimental value of the coefficient achieved almost total congruence with the coarse fraction collected for the tested velocities. For the vertical tests, the variation of the coefficient did not show significant differences for both collected fractions. The results obtained in this work allowed to gain a deeper insight into the studied gas-solid systems, and to improve the numerical predictions on fine particles classification processes widely used in the ceramic, mining and metallurgical industries.
A video is available at https://doi.org/10.48448/5jxb-r970
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
