https://doi.org/10.1051/epjconf/202429901013
Characteristics of droplets formed on the outer surface of the rotating packed bed
1 Energy Institute, Faculty of Mechanical Engineering, Brno University of Technology, Technická 2896/2, 616 69 Brno, Czech Republic
2 Department of Environmental Engineering, Faculty of Process and Environmnetal Engineering, Lodz University of Technology, Zeromskiego Street 116, 90-924 Lodz, Poland
* Corresponding author: Ondrej.Hajek3@vutbr.cz
Published online: 4 July 2024
A rotating packed bed (RPB), as a device for mass transfer enhancement, can be divided into three main parts. An eye of a rotor, a packing, and an outer cavity. It has been reported that a contribution to the total mass transfer of the outer cavity can reach up to 30% of the whole device. Mass transfer is highly influenced by the droplet hydrodynamics and dimensions, hence the liquid dispersion from the outer surface of a metal foam packing was recorded with a high-speed camera. The recordings were analysed with an in-house MATLAB® code to determine the droplet dimensions, and with a PIVlab software to evaluate velocity fields. It has been found that the droplet dimensions and velocities were influenced primarily by a packing speed, as the higher packing speed resulted in a presence of the smaller droplets. Two peaks in histograms for the droplet diameters could be explained with a breakup theory of a liquid jet which breaks into large, mother, and small, satellite droplets. The droplet velocity corresponded to a peripheral velocity of the packing. A liquid flow rate influenced only the number of droplets dispersed from the packing.
© The Authors, published by EDP Sciences, 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
