https://doi.org/10.1051/epjconf/20122502024
Experimental verification of numerical optimization of a plunger for glass pressing
1
Technical University of Liberec, Department of
Mathematics and Didactics of Mathematics, Studentská 2, Liberec 1, 461 17
This email address is being protected from spambots. You need JavaScript enabled to view it.
2
Technical University of Liberec, Department of
Power Engineering Equipment, Studentská 2, Liberec 1, 461 17
This email address is being protected from spambots. You need JavaScript enabled to view it.
The main aim of these experiments is to verify the results of numerical optimization described in [1], [2], [3] and [4]. The results of measuring the classical plunger with its drilled internal cavity and the optimized plunger with its sparked-out inner cavity and applied flow control body are presented in this article. The temperature distributions across both plunger surfaces are estimated by values measured at four points placed 5 millimetres under the plunger surfaces.
© Owned by the authors, published by EDP Sciences, 2012
