https://doi.org/10.1051/epjconf/20135913019
In situ calibration of the Gamma Reaction History instrument using reference samples (“pucks”) for areal density measurements
1 Los Alamos National Laboratory, PO Box 1663, Los Alamos, New Mexico 87545, USA
2 Atomic Weapons Establishment, Aldermaston, Berkshire RG7 4PR, UK
3 Lawrence Livermore National Laboratory, Livermore, California 94550, USA
4 National Security Technologies, LLC, Santa Barbara, California 93111, USA
5 Colorado School of Mines, Golden, Colorado 80401, USA
6 Laboratory for Laser Energetics, University of Rochester, Rochester, New York 14623, USA
Published online: 15 November 2013
The introduction of a sample of carbon, for example a disk or “puck”, near an imploding DT-filled capsule creates a source of 12C gamma rays that can serve as a reference for calibrating the response of the Gamma Reaction History (GRH) detector [1]. Such calibration is important in the measurement of ablator areal density ⟨ρR⟩abl in plastic-ablator DT-filled capsules at OMEGA [2], by allowing ⟨ρR⟩abl to be inferred as a function of ratios of signals rather than from absolute measurements of signal magnitudes. Systematic uncertainties in signal measurements and detector responses therefore cancel, permitting more accurate measurements of ⟨ρR⟩abl.
© Owned by the authors, published by EDP Sciences, 2013
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 2.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.