https://doi.org/10.1051/epjconf/202226401047
Contribution on the kinematics of the polishing process on a polishing machine with horizontal overarm
1
asphericon s.r.o., 463 12 Jeřmanice, Czechia
2
Technical university of Liberec, Institute of New Technologies and Applied Informatics, 461 17 Liberec, Czechia
3
Technical university of Liberec, Dept. of Power Engineering Equipment, 461 17 Liberec, Czechia
* Corresponding author: tomas.vit@tul.cz
Published online: 11 July 2022
Understanding and controlling of the polishing process on conventional NC controlled machines is an important step to optimize production, reduce machine time and increase quality of production. The paper deals with the basic analysis of the problem and its comparison with the experiment performed during the real process on the machine and with the numerical MBS simulation of the process.
© The Authors, published by EDP Sciences, 2022
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
