https://doi.org/10.1051/epjconf/202430903022
Simultaneous atmospheric pressure plasma jet etching and laser irradiation for ultra-precise optical glass processing
1 Leibniz Institute of Surface Engineering (IOM), Permoserstraße 15, 04318 Leipzig, Germany
2 Institute of Manufacturing Science and Engineering, Technische Universität Dresden, 01062 Dresden, Germany
* Corresponding author: Robert.Heinke@iom-leipzig.de
Published online: 31 October 2024
The use of beam-based technologies to process optical elements with nanoscale precision enables the fabrication of freeform surfaces. In particular, atmospheric pressure plasma jets (APPJs) have desirable properties, e.g., depth precision < 5 nm, low surface roughness and processing at atmospheric conditions. However, the composition of optical glasses and glass ceramics, containing metal oxides, leads to the formation of non-volatile reaction products that remain on the substrate surface. These residues reduce the etching rate and cause severe roughening of the surface. Laser irradiation has already been demonstrated as a promising option for removing the residual layer and the aim of the current work is to integrate it into the APPJ system for simultaneous processing. Therefore, an excimer laser (λ = 248 nm; tPulse = 20 ns) with a maximum pulse frequency of 100 Hz was added to a plasma jet setup and experiments with varying laser fluences as well as laser frequencies were performed on N-BK7 substrates. White light interferometry was used to analyse the samples. The experiments showed an improved etching result with higher removal rates for the combined process at high laser pulse frequency (100 Hz) and fluences in the range of 0.1-0.45 J·cm-2.
© The Authors, published by EDP Sciences, 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
